Description
Band:
- 14 Gauge (0.074?[1.88mm]) 304 stainless steel.
(S8 and S12) - 12 Gauge (0.105? [2.66mm]) 304 stainless steel.
(S12 = 40?#216; and up) Engineer/Contractor must specify. - 16 Gauge (0.061? [1.56mm]) 304 stainless steel. (Model SL8)
Flanges of the spacer are deep embossed and the corners are chamfered.
Configurations – Band
- 4? (101.6mm) through 36? (914mm) = 2-piece
- 36? (914mm) through 48? (1,219mm) = 3-piece
- 48? (1,219mm) and over = Consult Factory
Finish – None
Liner – Polyvinyl Chloride Liner (Standard)
- Thickness: 0.090? (2.29mm) minimum
- Hardness: Durometer “A” 85-90
- Dielectric Strength:
- 1/8? (3.18mm) Surge Test: 60,000 V min.
- Step-by-Step Test: 58,000 V min.
- Water Absorption: 1% max.
Liner – T.P.E. Liner (Temperature Extremes)
Model C12 Only
- Thickness: 0.118? (3.0mm)
- Hardness: Shore “A” 73
- Dielectric Strength:
- 1/8? (3.18mm) Surge Test: 60,000 V min.
- Step-by-Step Test: 58,000 V min.
- Water Absorption: 1% max.
- Temperature: -50 to 270°F. (-45 to 132°C.)
Risers
- 10 Gauge (0.135? [3.43mm]) 304 stainless steel MIG welded to band.
(standard S8 and S12) - 7 Gauge (0.179? [4.55mm]) steel MIG welded to band. (Contact PSI)
- 12 gauge (0.105? [2.667mm]) steel MIG welded to band (Model SL8)
Hardware (Threaded Studs, Nuts and Washers)
- Threaded Studs = 5/16? – 18 x 2-1/2?
304 staianless steel or plated - Hex Nuts = 5/16?
- Washers = 5/16? SAE 2330
Configurations (Threaded Studs, Nuts and Washers)
- 8? (203.2mm) Band = 6 studs, 12 nuts and washers
- 12? (305mm) Band = 8 studs, 16 nuts and washers
